Ausbau der Nockenwelle

[883yan]

after finishing to rebuild my gearbox, I finally finished a complete tear-down of my engine. The camshaft was a real pain to remove as I do not have the special puller tool and could not find one for sale.

-I used a large screwdriver and hammer to drive out the first bearing from the inside.
-Then i used tire irons to pull out the camshaft by using it as a lever against the back bearing
-Then I removed the tappet so that the back bearing could be pulled out
-Lastly, and that was the easiest part, I used a blind bearing puller to get the inside bearing out
A lot of heat was used along the way from a heat gun.

I took photos along the way in case someone needs help doing the same.

IMG_20191003_165705.jpg

IMG_20191003_170737.jpg

IMG_20191003_170128.jpg

More photos of the camshaft removal here.
https://photos.app.goo.gl/YxG7kDkGiox4i5257

Full set of photos here:
https://photos.app.goo.gl/Fko5NXLBAJbuiz2j9

[Christoph]

Hallo,
in the first picture of that link you will find a real useful tool
viewtopic.php?f=34&t=1380
is was some years ago, but maybe our member Inge can show you the details of his design.
I was buying it and I can say that it made the job much more easier.
regards
Christoph

[883yan]

Thanks Christoph.
I was actually looking to buy that same puller tool but couldn't find any for sale. Hopefully I never have to pull that camshaft out again! But it I do I might very well wait until I get one of these pullers.

[speedvogt]

Schade,ich kann nur Russisch.