Seite 1 von 1
Passenger Seat
Verfasst: Do 7. Jan 2010, 20:49
von BikerWannabe
Hi folks, how to remove this shaft from the passenger's seat?
I tried to hammer it out but it didn't move.
Maybe it is fixed in there with something?
Or maybe it is welded inside?
See photo below.
Re: Passenger Seat
Verfasst: Do 7. Jan 2010, 21:27
von awo-junkie
Hi Biker,
may be there is a rest from such a grease nipple left in the hole.
It would make no sense to weld there anything.
I would use a 6mm drill for cleaning the hole and a nice hammer for the rest of the job.
Good luck!
Re: Passenger Seat
Verfasst: Do 7. Jan 2010, 21:42
von krachbumm425
Hi biker,
The shaft is rusted shut.
try it sometimes with warmth.
uwe
Re: Passenger Seat
Verfasst: Do 7. Jan 2010, 21:45
von awolli
WD40......
Re: Passenger Seat
Verfasst: Do 7. Jan 2010, 22:39
von BikerWannabe
Thanks, guys!
I already sprayed it with WD40.
Will try what krachbumm425 advised me - heat up the tube around the shaft.
Re: Passenger Seat
Verfasst: Fr 8. Jan 2010, 08:54
von ranger
aha
Re: Passenger Seat
Verfasst: Fr 8. Jan 2010, 10:22
von krachbumm425
well, I have them sit several times restored.
I have it repaired as always.
of course you need a real burner, propane or acetylene.
uwe
Re: Passenger Seat
Verfasst: Fr 8. Jan 2010, 20:29
von BikerWannabe
I tried with a hot air gun. The shaft moved just a little bit.
Will try with a propane burner.